Independent 6'2" North American athlete Eric Bishop introduced a dunk entitled the 'Paint Job'. The title is in reference to the key on a basketball court, often known as 'paint' in common parlance.[36] Approaching along the baseline with a running dribble, Bishop jumped with one-foot at the border of the key, dunked with one-hand while gliding over the key and landed just beyond the border on the side opposite his take-off—a 16-foot flight.
Like Todd and me, Nicholson was a two-foot jumper, and he echoed what Todd had told me was another flaw in my technique: “Your next-to-last step has to be a lot bigger. That big leap forward with your right foot—your penultimate step—that’s what allows you to explode off the ground.” To demonstrate, Nicholson sent me a video of Carter’s performance at the 2000 NBA Dunk Contest, which was a bit like showing a Monet to a finger painting kindergartner and saying, “No, like this.”
Another high pull option is to shorten the range of motion to make it a hang high pull instead of a power high pull (“power” implying that the load starts on the floor). In this case, the start position is from standing, with the bar hanging in front of your thighs at arms’ length. The movement is initiated with a dip in the hips and knees, so that the bar lowers to just above knee level, followed immediately by an explosive pull.
This is a high quality gear set for the next generation recoil shock series.  They only use one gear set through out the entire range, so this will fit all NEXT gen guns. This is a extremely well made piece of kit, This is possibly one of the strongest gear sets on the market, i would say the main benefit over other gear sets is its tuning option, you can by it in both single torque which is a little over the standard gear ratio and the double torque which is a lot over the standard ratio. Both provide increased torque up on the gun ie less effort to turn the spring, which in turn gives you increased battery life and and faster trigger response, sacrificing a little ROF. Although technically they should see a decrease in ROF because of the ratio, ive actually seen increases in ROF because of how efficient these gears are and because they are balanced.  Expensive gears but a very awesome piece of kit if these where cheaper they would no doubt be in ever ones guns.. no exceptions.
I found out that if you practice penultimate two-step jumping practice dunking or just jumping, it gives a MUCH better workout than any one step jumping practice. I was also able to increase my one foot jump vertical by this. I think 2-step dunking is much more powerful and waaaaaay cooler. It is also much safer because you are in more control of your body. Right now I'm 6'1" and can 2-step tomahawk and basically everything off one foot

A strut is a major structural part of a suspension. It takes the place of the upper control arm and upper ball joint used in conventional suspensions. Because of its design, a strut is lighter and takes up less space than the shock absorbers in conventional suspension systems. Struts perform two main jobs. First, struts perform a damping function like shock absorbers. Internally, a strut is similar to a shock absorber. A piston is attached to the end of the piston rod and works against hydraulic fluid to control spring and suspension movement. Just like shock absorbers, the valving generates resistance to forces created by the up and down motion of the suspension. Also like shock absorbers, a strut is velocity sensitive, meaning that it is valved so that the amount of resistance can increase or decrease depending on how fast the suspension moves.
i am a basketball player! i''m interest in dunk, but my height is 165cm then it made me more diffidult to do it!i was spent 2 years to training jumping,finally i''m able to touch the rim!my problem is the training cant help me jump further! In here, i would like to ask for any method that can help me to achieve my goal which i can do a perfect slam dunk.
Vertical jumps are used to both train and test for power output in athletes. Plyometrics are particularly effective in training for power output, and include vertical jumps of different types in their protocol. In one recent study, training with plyometrics (which included continuous vertical jumps) was shown to improve jump height and boost vertical jump performance to similar degrees in combination with very different resistance training protocols, indicating that the plyometric jumping contributed to the increased jump height more than resistance training. Research into plyometric jumps found vertical jumps to be among the highest in terms of muscle recruitment (as measured by electromyography), power output, and ground reaction force produced.[8][9][10] Fatigue has been researched in athletes for its effect on vertical jump performance, and found to decrease it in basketball players, tennis players, cyclists, rugby players, and healthy adults of both genders.[11][12][13]
×