At the competitive level (i.e., the NFL and NBA combines), vertical leap is measured using a “jump tester”—a tripod with a series of thin plastic sticks one inch apart. If you have access to this equipment, it’s your best bet for getting an accurate measurement. A cheaper, more feasible option is to do your jump next to a wall and mark the highest point you touch with a piece of chalk.

Struts also perform a second job. Unlike shock absorbers, struts provide structural support for the vehicle suspension, support the spring, and hold the tire in an aligned position. Additionally, they bear much of the side load placed on the vehicle's suspension. As a result, struts affect riding comfort and handling as well as vehicle control, braking, steering, wheel alignment and wear on other suspension


variations: The vertical jump test can also be performed using a specialized apparatus called the Vertec. The procedure when using the Vertec is very similar to as described above. Jump height can also be measured using a jump mat which measures the displacement of the hips. To be accurate, you must ensure the feet land back on the mat with legs nearly fully extended. Vertical jump height can also be measured using a timing mat. The vertical jump test is usually performed with a counter movement, where there is bending of the knees immediately prior to the jump. The test can also be performed as a squat jump, starting from the position of knees being bent. Other test variations are to perform the test with no arm movement (one hand on hip, the other raised above the head) to isolate the leg muscles and reduce the effect of variations in coordination of the arm movements. The test can also be performed off one leg, with a step into the jump, or with a run-up off two feet or one foot, depending on the relevance to the sport involved. For more details see vertical jump technique.
I continued to follow the program for the next few weeks, and I was dunking fairly regularly. I got a friend to film me, and then bored everyone I knew by showing them the video for weeks on end, like a proud father of my own dunk. Each one was the same: I could only do it after a couple days’ rest, and only with a ball I could palm. I approached from the left, jumped off two feet, and dunked with my right hand. There would be no cocked-back, in-your-face, two-handed throw downs; no acrobatic Russell Westbrook highlight reel slams.
variations: The vertical jump test can also be performed using a specialized apparatus called the Vertec. The procedure when using the Vertec is very similar to as described above. Jump height can also be measured using a jump mat which measures the displacement of the hips. To be accurate, you must ensure the feet land back on the mat with legs nearly fully extended. Vertical jump height can also be measured using a timing mat. The vertical jump test is usually performed with a counter movement, where there is bending of the knees immediately prior to the jump. The test can also be performed as a squat jump, starting from the position of knees being bent. Other test variations are to perform the test with no arm movement (one hand on hip, the other raised above the head) to isolate the leg muscles and reduce the effect of variations in coordination of the arm movements. The test can also be performed off one leg, with a step into the jump, or with a run-up off two feet or one foot, depending on the relevance to the sport involved. For more details see vertical jump technique.
Using only a lifting (concentric) phase for strength training exercises could also be more effective for improving vertical jump height than traditional, stretch-shortening cycle exercises under load, for two reasons. Firstly, using only a lifting phase involves faster rate of force development through higher rate coding, and this may increase high-velocity strength more over the long-term. Secondly, doing stretch-shortening cycle exercises under load *might* cause the tendons to increase stiffness to a greater extent. This would make the muscle lengthen more in the countermovement phase of a jump, and thereby reduce muscle force for a given countermovement depth.

As far as sequels go, Ninn learned a lesson from his ill-fated follow-up to SEX. Without even a second of flashback footage, he designed SHOCK to surpass LATEX in every respect. It succeeds in some ways. In others, it merely (ha !) equals or falls just below its immediately illustrious predecessor. Simply put, and you can quote me on this, if LATEX blew your mind, SHOCK will turn it inside out !
Vertical jump measurements are used primarily in athletic circles to measure performance. The most common sports in which one's vertical jump is measured are track and field, netball, basketball, football, and volleyball, but many sports measure their players' vertical jumping ability during physical examinations. In addition, single and multiple vertical jumps are occasionally used to assess muscular strength and anaerobic power in athletes.[3]
×